KADMAC Multi-Rotor solo test
First Name…………………………………………………………
KADMAC Membership Number…………………………….
Check List
Done
| (a) | Carry out pre-flight checks as required by the BMFA Safety Codes. | |
| (b) | Take off and hover 20 meters out and demonstrate failsafe/return to home function. | |
| The following (c to j) tests to be completed with GPS switched off. | ||
| (c) | Take off and hover tail in over the take off point, with the multi-rotor skids at eye level, for about twenty seconds and then land | |
| (d) | Take off and hover for about five seconds then hover the multirotor slowly forwards for approximately five metres, stop, and hover for about five seconds. | |
| (e) | Hover the multi-rotor slowly sideways, either left or right, for approximately five metres, stop, and hover for about five seconds | |
| (f) | Hover the multi-rotor slowly sideways in the opposite direction for approximately ten metres, passing in front of the pilot, stop, and hover for about five seconds | |
| (g) | Hover the multi-rotor slowly sideways in the opposite direction for approximately five metres, returning to the position in front of the pilot, stop, and hover for about five seconds | |
| (h) | Fly slowly backwards, bringing the multi-rotor back over the take off point, stop, hover for about five seconds and land | |
| (i) | Take off and fly forward for 5 metres, hover for about five seconds, then turn sideways 90 degrees either left or right and fly forward to perform two ‘lazy eights’, each at least 30 metres in length | |
| (j) | At the conclusion of the ‘lazy eights’, bring the multi-rotor to a halt above the centre point, turn tail-in to the pilot, hover for about five seconds and return to the landing pad | |
| (k) | Complete post-flight checks required by the BMFA Safety Codes. |
(b) Members with craft not equipped with GPS, will be asked to remove their propellers and demonstrate failsafe in a safe area.